P0345 NISSAN Camshaft Position Sensor Circuit Bank 2

Possible causes
– Faulty Camshaft Position Sensor
– Camshaft Position Sensor harness is open or shorted
– Camshaft Position Sensor circuit poor electrical connection
– Faulty starter motor
– Starting system circuit
– Dead (Weak) battery
Tech description
There is a factory service bulletin for the following Nissan models:

2003 Nissan Altima
2004 Nissan Altima
2005 Nissan Altima
2004 Nissan Quest
2004 Nissan Maxima
Nissan Factory Service Bulletin OBDII Code P0345

When is the obd code mean?
The camshaft position sensor signal is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Lack/Loss of Power
– Engine Stall
P0345 NISSAN OBD Code Description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.

When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

NISSAN Related P0345 code
2003 NISSAN ALTIMA Electrical System
2004 NISSAN ALTIMA Electrical System
2004 NISSAN MAXIMA Electrical System
2004 NISSAN QUEST Electrical System
2005 NISSAN ALTIMA Electrical System