Land Rover P0233 Throttle Position Sensor 2 Circuit Low

Description

OBD-II Trouble Code Description for P0233 Land Rover

Fuel Pump Secondary Circuit Intermittent

What does this mean?

OBD2 Code P0233 Land Rover definition:
The powertrain control module (PCM) provides ignition positive voltage to the coil side of the fuel pump relay. When the ignition switch is first turned ON, the PCM energizes the fuel pump relay, which applies power to the fuel pump. The PCM enables the fuel pump relay as long as the engine is cranking or running, and crankshaft reference pulses are received. If no crankshaft reference pulses are received, the PCM de-energizes the fuel pump relay after 2 seconds. The PCM monitors the voltage on the fuel pump relay control circuit.

Symptoms

Possible sumptoms of OBD code P0233 Land Rover
– Engine Light ON (or Service Engine Soon Warning Light)

Causes

Possible causes of OBD code P0233 Land Rover
– Open Inertia Switch – Blown Fuel Pump fuse – Open Fuel Pump Monitor Circuit – Open Fuel Pump Control Circuit – Faulty Fuel Pump Relay – Damaged PCM. The Error code is generally activated on detection of the following conditions: The code will be set if an intermittent voltage on the control circuit of the fuel pump relay is detected by the PCM.

Possible Solutions

For some FORD models: 1. Disconnect the inertia switch harness connector. 2. Turn key to ON position (Engine OFF) 3. Measure voltage of circuit between inertia switch harness connector and ground. 4. If battery voltage is found, replaced Inertia Switch. 5. Clear codes.


The OBD2 Code Information Be Applicable For Land Rover:

2013 Land Rover,2012 Land Rover,2011 Land Rover,2010 Land Rover,2009 Land Rover ,2008 Land Rover,2007 Land Rover,2006 Land Rover,2005 Land Rover,2004 Land Rover,2003 Land Rover,2002 Land Rover

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Land Rover makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.