Description
OBD-II Trouble Code Description for P0541 Land Rover
Intake Air Heater “A” Circuit Low
What does this mean?
OBD2 Code P0541 Land Rover definition:
The engine control module (ECM) uses an intake air heater (IAH) to warm the incoming air for proper cylinder combustion. The ECM grounds the control coil of the IAH relay to energize the heater during cold operation. The ECM sends a bias voltage on diagnostic circuits one and two.
Symptoms
Possible sumptoms of OBD code P0541 Land Rover
– Engine Light ON (or Service Engine Soon Warning Light)
Causes
Possible causes of OBD code P0541 Land Rover
– Open or short intake air heater relay circuit condition – Intake air heater relay poor electrical connection – Faulty Intake Air Heater Relay The Error code is generally activated on detection of the following conditions: The P0541 Land Rover code is detected when the Signal from the #1 intake air heater output does not match the signal input
Possible Solutions
The OBD2 Code Information Be Applicable For Land Rover:
2013 Land Rover,2012 Land Rover,2011 Land Rover,2010 Land Rover,2009 Land Rover ,2008 Land Rover,2007 Land Rover,2006 Land Rover,2005 Land Rover,2004 Land Rover,2003 Land Rover,2002 Land Rover
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Land Rover makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.