Description
OBD-II Trouble Code Description for P0102 Mini
Mass or Volume Air Flow Circuit Low Input
What does this mean?
OBD2 Code P0102 Mini definition:
Basically this means that there is a problem with the Mass Air Flow (MAF) sensor or circuit. A more technical description would be that the MAF circuit had lower than expected voltage (air flow).
Symptoms
Possible sumptoms of OBD code P0102 Mini
You will likely not notice any serious drivability problems, although there may be symptoms such as a general decrease in power or sluggishness.
Causes
Possible causes of OBD code P0102 Mini
The MAF may be disconnected, or a wiring connection may be bad The MAF may be dirty or otherwise contaminated (Note: if you use a reusable oiled air filter, be careful not to apply too much oil or that can contaminate the MAF). The MAF sensor may be faulty The vehicle computer may be faulty (very rare)
Possible Solutions
The simplest thing to do is to reset the code and see if it comes back. Then start with the cheapest, easiest repair procedures: Verify that the Mass Air Flow Sensor wiring is connected properly and that there are no broken / frayed wires. Inspect for any air leaks near the MAF sensor. Take the MAF out and clean it using a spray cleaner such as brake cleaner or electrical contact cleaner. Be gentle with the sensor. Check the voltage of the MAF sensor (refer to a repair manual for vehicle specific information) Replace the MAF sensor.
The OBD2 Code Information Be Applicable For Mini:
2013 Mini Vision Concept,2013 Mini Roadster,2013 Mini Cooper,2013 Mini Countryman,2013 Mini Clubvan Camper,2013 Mini Clubvan,2013 Mini Clubman Bond Street,2012 Mini Rocketman Concept,2012 Mini Coupe,2012 Mini Clubvan Concept,2012 Mini Bayswater,2012 Mini Baker Street,2011 Mini WRC,2010 Mini Scooter,2009 Mini Cooper,2008 Mini One,2008 Mini Cooper,2008 Mini Clubman,2007 Mini Cooper,2006 Mini Concept,2005 Mini Cooper,2004 Mini XXL,2004 Mini Cooper,2002 Mini Cooper,2000 Mini Seven,2000 Mini Cooper
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Mini makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.