Cadillac P0403 Exhaust Gas Recirculation Control Circuit

Description

OBD-II Trouble Code Description for P0403 Cadillac

Exhaust Gas Recirculation Control Circuit

What does this mean?

OBD2 Code P0403 Cadillac definition:
The Exhaust Gas Recirculation (EGR) system is controlled by a vacuum solenoid. The solenoid is supplied ignition voltage. The Powertrain Control Module (PCM) controls the vacuum solenoid by grounding the control circuit(ground) or driver. The primary function of the driver is to supply ground for the object that is being controlled. Each driver has a fault circuit that the PCM monitors. When the PCM turns a component on, the control circuit voltage is low, or close to zero. When the component is turned off, the voltage on the control circuit is high, or near battery voltage. The PCM watches for these conditions, and if it doesn’t see the proper voltage at the proper time, this code is set.

Symptoms

Possible sumptoms of OBD code P0403 Cadillac
Usually a fault in the control circuit, will leave no noticeable symptoms other than the Malfunction Indicator Lamp (MIL) illumination. However, if the EGR control solenoid is stuck open due to debris, etc. the code may be accompanied by misfire under acceleration, rough idle, or engine dying altogether.

Causes

Possible causes of OBD code P0403 Cadillac
The causes for a P0403 Cadillac EGR code could be any of the following: Bad EGR solenoid Excessive resistance in control circuit (PCM controlled ground) due to an open, chafing or damage to the harness Poor connection at the EGR solenoid harness (worn or loose pins) Water intrusion at the EGR solenoid harness Blockage in EGR control solenoid holding solenoid open or closed causing excessive resistance Loss of supply voltage to EGR solenoid Bad PCM

Possible Solutions

With the ignition on and engine off, use a scan tool to activate the EGR solenoid. Listen or feel for a clicking, indicating that the solenoid is operating. If the solenoid does operate, you’ll have to check current draw on the ground circuit. It should be less than one amp. If it is then the problem is intermittent. If it isn’t then there is excessive resistance in the circuit and perform the following 1. When it’s activated see if you can blow lightly through it. IF you can’t there may be a blockage causing excessive resistance. Replace EGR solenoid as needed. If there is no blockage, disconnect the EGR solenoid and the PCM connector containing the EGR solenoid control circuit. Using a digital Volt-Ohm meter (DVOM) check resistence between the control circuit and battery ground. It should be infinite. If it isn’t, then there is a short to ground on the control circuit. Repair the short to ground and retest as needed. 2. If the solenoid doesn’t click as it should, disconnect the EGR solenoid connector and connect a test light between the two wires. Using the scan tool, command the EGR solenoid on. The light should light up. If it does, replace the EGR solenoid. If it does not perform the following: a. Check for 12 Volts on the ignition supply voltage to the solenoid. If it isn’t present, inspect the supply circuit for an open, or a short due to chafing or breakage and re-test. b. If it still doesn’t operate: then manually ground the EGR solenoid control circuit. The light should light. If it does, repair open in EGR solenoid control circuit and re-test. If it doesn’t, replace EGR solenoid.

Related Codes

P0400 Cadillac P0401 Cadillac P0402 Cadillac


The OBD2 Code Information Be Applicable For Cadillac

2013 Cadillac XTS,2013 Cadillac Elmiraj Concept,2013 Cadillac ATS,2012 Cadillac SRX,2011 Cadillac Ciel Concept,2011 Cadillac CTS Coupe,2011 Cadillac CTS-V Sport Wagon,2011 Cadillac CTS-V Coupe Race Car,2011 Cadillac CTS-V Coupe,2011 Cadillac CTS-V Black Diamond Edition,2010 Cadillac XTS Platinum Concept,2010 Cadillac Urban Luxury Concept,2010 Cadillac SRX,2010 Cadillac SLS,2010 Cadillac CTS Sport Wagon,2010 Cadillac Aera Concept,2009 Cadillac Presidential Limousine,2009 Cadillac Escalade Hybrid,2009 Cadillac Converj Concept,2009 Cadillac CTS-V,2008 Cadillac STS,2008 Cadillac Provoq Concept,2008 Cadillac Escalade Platinum,2008 Cadillac CTS Coupe Concept,2008 Cadillac CTS,2008 Cadillac BLS Wagon,2007 Cadillac SRX European Version,2007 Cadillac SLS,2007 Cadillac Escalade European Version,2007 Cadillac Escalade EXT,2007 Cadillac Escalade ESV,2007 Cadillac Escalade,2007 Cadillac BLS Sport,2006 Cadillac XLR Star Black Limited Edition,2006 Cadillac XLRV,2006 Cadillac STSV,2006 Cadillac SRX,2006 Cadillac Escalade ESVe Limousine,2006 Cadillac DTS Limousine,2006 Cadillac DTS,2006 Cadillac CTS,2006 Cadillac BLS,2005 Cadillac XLR Euro,2005 Cadillac STS SAE 100,2005 Cadillac STS Euro,2005 Cadillac STS,2005 Cadillac SRX Euro,2005 Cadillac SRX,2005 Cadillac CTS Euro,2005 Cadillac CTS-V Euro,2005 Cadillac BLS Show Car,2004 Cadillac XLR,2004 Cadillac Seville SLS,2004 Cadillac SRX,2004 Cadillac Escalade ESV Platinum,2004 Cadillac Escalade ESV Executive Edition,2004 Cadillac DeVille Armored,2004 Cadillac CTSV Race Car,2004 Cadillac CTSV,2004 Cadillac CTS,2003 Cadillac Sixteen Concept,2003 Cadillac Escalade EXT,2003 Cadillac Escalade ESV,2003 Cadillac CTSV with Accessories,2003 Cadillac CTS,2002 Cadillac Vizon Concept,2002 Cadillac Seville STS,2002 Cadillac Escalade EXT,2002 Cadillac Escalade,2002 Cadillac DeVille,2002 Cadillac Cien Concept,2001 Cadillac Seville,2001 Cadillac Eldorado,2001 Cadillac DeVille Presidential Limousine,2001 Cadillac DeVille DTS,2000 Cadillac Seville STS,2000 Cadillac Imaj Concept,2000 Cadillac Escalade,2000 Cadillac Eldorado ETC,2000 Cadillac DeVille

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Cadillac makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.