P0740 JEEP Torque Converter Clutch Circuit

Possible causes
– Low transmission fluid level
– Dirty transmission fluid
– Faulty torque converter clutch solenoid valve
– Torque converter clutch solenoid valve harness is open or shorted
– Torque converter clutch solenoid valve circuit poor electrical connection
When is the obd code mean?
Torque Converter Clutch (TCC) unlocked for 10 sec., ECM commands converter lock-up and did not record engine speed drop.
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
– Transmission shift shock
– Vehicle may not shift into the highest gear
P0740 JEEP OBD Code Description

The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.

Lock-up operation, however, is prohibited when A/T fluid temperature is too low.

When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

JEEP Related P0740 code
2008 JEEP LIBERTY Power Train:automatic Transmission
2008 JEEP LIBERTY 4X4 Power Train:automatic Transmission
2008 JEEP WRANGLER Power Train:automatic Transmission
2008 JEEP WRANGLER 2-DR 4X4 Power Train:automatic Transmission
2008 JEEP WRANGLER 2-DR 4X4 RHD Power Train:automatic Transmission
2008 JEEP WRANGLER 4-DR 4X2 Power Train:automatic Transmission
2008 JEEP WRANGLER 4-DR 4X4 Power Train:automatic Transmission