Description
OBD-II Trouble Code Description for P0722 Ford
Output Speed Sensor Circuit No Signal
What does this mean?
OBD2 Code P0722 Ford definition:
The speed sensor detects the revolution of the idler gear parking pawl lock gear and emits a pulse signal. The pulse signal is sent to the Transmission Control Module (TCM) which converts it into vehicle speed.
Symptoms
Possible sumptoms of OBD code P0722 Ford
– Engine Light ON (or Service Engine Soon Warning Light) – Speedometer improper reading – Possible shifting problems
Causes
Possible causes of OBD code P0722 Ford
– Speed sensor harness or connectors – Sensor circuit is open or shorted – Speed sensor The Error code is generally activated on detection of the following conditions: The output shaft speed sensor failed to provide a signal to the TCM upon initial movement of vehicle.
Possible Solutions
The OBD2 Code Information Be Applicable For Ford:
2013 Ford Taurus,2013 Ford Mustang,2013 Ford Kuga,2013 Ford Fusion,2012 Ford Focus,2011 Ford Mondeo,2011 Ford Focus,2011 Ford Edge,2010 Ford Mustang,2009 Ford Focus,2008 Ford Fiesta,2008 Ford Escape,2007 Ford Mondeo,2006 Ford Focus,2005 Ford Mustang,2005 Ford Escape,2003 Ford Mustang,2003 Ford Focus,2000 Ford Mustang
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Ford makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.