Dodge P0104 Mass Air Flow Sensor Throttle Angle and Speed

Description

OBD-II Trouble Code Description for P0104 Dodge

Mass or Volume Air Flow Circuit Intermittent

What does this mean?

OBD2 Code P0104 Dodge definition:
Basically this means that there is a problem with the Mass Air Flow High (MAF) sensor or circuit. A more technical description would be that the MAF is producing incorrect air flow readings.

Symptoms

Possible sumptoms of OBD code P0104 Dodge
You will likely not notice any serious drivability problems, although there may be symptoms such as a general decrease in power or sluggishness.

Causes

Possible causes of OBD code P0104 Dodge
The mass air flow (MAF) circuit is incomplete (broken / frayed wire, etc.) There is an air leak in the intake system

Possible Solutions

The simplest thing to do is to reset the code and see if it comes back. Then start with the cheapest, easiest repair procedures: Verify that the Mass Air Flow Sensor wiring is connected properly and that there are no broken / frayed wires. Inspect for any air leaks near the MAF sensor. Check the voltage of the MAF sensor (refer to a repair manual for vehicle specific information) Replace the MAF sensor.

Related Codes

P0100 Dodge P0101 Dodge P0102 Dodge P0103 Dodge