Dodge P1000 OBD system readiness test not complete

Description

OBD-II Trouble Code Description for P1000 Dodge

OBD-II Monitor Testing Incomplete

OBD-II Trouble Code Description for P1000 Dodge

OBD system readiness test not complete

What does this mean?

OBD2 Code P1000 Dodge definition:
The OBD monitors are performed during the OBD Drive Mode. The P1000 Dodge will be stored in continuous memory if any of the OBD monitors do not complete their full diagnostic check.

Causes

Possible causes of OBD code P1000 Dodge
? Vehicle is new from the factory ? Battery or PCM had recently been disconnected ? An OBD monitor failure had occurred before completion of an OBD drive mode ? The PCM DTCs have recently been cleared with a M-MDS ? The PCM has been flashed and the vehicle has not yet completed an OBD drive mode.

Possible Solutions

Diagnostic procedure

STEP

INSPECTI DodgeON

ACTION Dodge
1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDE DodgeD
???Has the FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY REPAIR INFORMATION AVAILABILIT DodgeY
???Verify related service repair information availability.
???Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
CHECK Dodge FOR ANY OTHER DTCS
???Where any other DTCs received with the P1000 Dodge?
Yes
Go to the applicable DTC inspection.
No
Go to the next step.
4
REQUEST TO CLEAR Dodge DTC P1000 Dodge
Note
???A complete OBD drive mode has not yet been performed to clear the DTC P1000 Dodge from the PCM.

???Has the customer requested the DTC P1000 Dodge be cleared?
Yes
Complete an OBD drive mode, then go to the next step.
No
Inform the customer that if the law in your area required additional driving in order to clear the DTC P1000 Dodge from the PCM memory, it must be complete before an inspection/maintenance test.
5
VERIFY THAT DTC P1000 Dodge TROUBLES DodgeHOOTING IS COMPL DodgeETED
???Make sure to reconnect all disconnected connectors.
???Clear the DTC from the PCM memory using the M-MDS.
???Start the engine and warm-up to normal operating temperature.
???Run the vehicle under the FREEZE FRAME DATA stored condition.
???Retrieve the DTC using the M-MDS.
???Is the PENDI DodgeNG CODE same DTC present?
Yes
Replace PCM, then go to the next step.
No
Go to the next step.
6
VERIFY AFTER REPAIR PROCE DodgeDURE
???Perform “After Repair Procedure”.
???Is there any DTC present?
Yes
Go to the applicable DTC inspection.
No
Troubleshooting completed.

Mercedes OBD-II Trouble Code Description for P1000 Dodge

Electronic Gear Selector Module: Defective N15/5