OBD-II Trouble Code Description for P0062 Ford

HO2S Heater Control Circuit

What does this mean?

OBD2 Code P0062 Ford definition:
Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM). In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground. The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

Symptoms

Possible sumptoms of OBD code P0062 Ford
– Engine Light ON (or Service Engine Soon Warning Light)

Causes

Possible causes of OBD code P0062 Ford
– Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 circuit open shorted to ground – Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 circuit poor electrical connection – Faulty Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 circuit – Heated Oxygen Sensor (H2OS) Bank 2 Sensor 3 circuit fuse – Faulty Engine Control Module (ECM) The Error code is generally activated on detection of the following conditions: The P0061 Ford is set when the ECM detects an open or shorted to ground condition on the heated oxygen sensor heater circuit

Possible Solutions

The code means that there is a problem with the heater element circuit of the heated oxygen sensor. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow, which is a very common problem for this type codes. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors.