Description
OBD-II Trouble Code Description for P0736 Ford
Reverse Incorrect Ratio
What does this mean?
OBD2 Code P0736 Ford definition:
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows: Torque converter slip ratio = A x C/B A: Output shaft revolution signal from revolution sensor B: Engine speed signal from Engine Control Module (ECM) C: Gear ratio determined as gear position which TCM supposes
Symptoms
Possible sumptoms of OBD code P0736 Ford
– Engine Light ON (or Service Engine Soon Warning Light) – Incorrect transmission shifting
Causes
Possible causes of OBD code P0736 Ford
– Low transmission fluid level – Dirty transmission fluid – Shift solenoids – Transmission mechanical problems – Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions
Possible Solutions
The OBD2 Code Information Be Applicable For Ford:
2013 Ford Taurus,2013 Ford Mustang,2013 Ford Kuga,2013 Ford Fusion,2012 Ford Focus,2011 Ford Mondeo,2011 Ford Focus,2011 Ford Edge,2010 Ford Mustang,2009 Ford Focus,2008 Ford Fiesta,2008 Ford Escape,2007 Ford Mondeo,2006 Ford Focus,2005 Ford Mustang,2005 Ford Escape,2003 Ford Mustang,2003 Ford Focus,2000 Ford Mustang
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Ford makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.