Description
OBD-II Trouble Code Description for P0453 Infiniti
Evaporative Emission System Pressure Sensor/Switch High
What does this mean?
OBD2 Code P0453 Infiniti definition:
The EVAP (Evaporative Emissions) System allows fuel tank vapors to be purged into the engine and burnt rather than expelled into the atmosphere as harmful emissions. The EVAP system contains a pressure sensor to check the integrity of the system. Periodically, the EVAP system performs a pressure test to check that there are no leaks in the system. It uses this sensor, also known as a fuel tank pressure (FTP) sensor to check for leaks. Basically P0453 Infiniti means the PCM (Powertrain Control Module) noticed the EVAP Pressure sensor or FTP is indicating a higher than normal pressure (above 4.5 Volts) in the EVAP system. NOTE: On some vehicles the FTP is a part of the fuel pump assembly in the tank.
Symptoms
Possible sumptoms of OBD code P0453 Infiniti
There will likely be no noticeable symptoms along with this code other than the MIL (Malfunction Indicator Lamp), commonly known as Check Engine Light illumination. However, there may be noticeable fuel odors in some cases.
Causes
Possible causes of OBD code P0453 Infiniti
A P0453 Infiniti DTC trouble code may be caused by one or more of the following: Open on FTP sensor signal wire Short to voltage on FTP sensor signal wire Bad FTP sensor Abnormally high pressure in fuel tank due to blockage in EVAP purge hoses or overfilled tank Loose/damaged FTP sensor connector Loss of ground to the sensor
Possible Solutions
Using an scan tool access FTP sensor value with Key on Engine off (KOEO). Normal value is usually somewhere near 2.5 Volts at atmospheric pressure (may fluctuate some due to altitude). It shouldn’t ever be above 4.5 Volts. 1) If it is close to 2.7V with the gas cap off, the problem is likely intermittent. Using a Digital Volt Ohm Meter, measure the voltage on the signal wire while trying to induce the problem by wiggle testing all the wiring at the FTP sensor. If the voltage fluctuates when wiggle testing, check for connector problems; i.e. water in the connector, broken or chafed wiring. 2) If the value shown on the scan tool is above 4.5V, unplug the sensor (if possible) and check for voltage again. If the high voltage is still present when unplugged, inspect wiring harness for a short to voltage on the signal wire. If the high voltage disappears when unplugging the sensor, check for a good ground to the sensor and proper reference voltage. If you have a good ground and 5 Volts reference voltage, replace the FTP sensor since it’s likely shorted out.
The OBD2 Code Information Be Applicable For Infiniti:
,2013 Infiniti M35h GT,2013 Infiniti JX,2013 Infiniti FX,2011 Infiniti QX,2011 Infiniti M35h,2011 Infiniti M,2011 Infiniti JX Concept,2011 Infiniti IPL G Coupe,2011 Infiniti EX30d,2009 Infiniti G37,2009 Infiniti FX50,2009 Infiniti FX37,2009 Infiniti FX35,2009 Infiniti Essence Concept,2009 Infiniti EX37,2008 Infiniti QX56,2008 Infiniti M45x,2008 Infiniti M45s,2008 Infiniti G37 Coupe,2008 Infiniti EX35,2007 Infiniti G35 Sedan,2007 Infiniti EX Concept,2006 Infiniti QX56,2006 Infiniti Q45,2006 Infiniti M45,2006 Infiniti M35x,2006 Infiniti M35,2006 Infiniti FX45,2005 Infiniti Q45,2005 Infiniti G35,2005 Infiniti FX45,2004 Infiniti QX56,2004 Infiniti M45 Concept,2004 Infiniti I35,2003 Infiniti QX4,2003 Infiniti Q45,2003 Infiniti M45,2003 Infiniti I35,2003 Infiniti G35,2003 Infiniti FX45,2003 Infiniti FX35
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Infiniti makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.