Isuzu P0520 Engine Oil Pressure Sensor/Switch Circuit Malfunction

Description

OBD-II Trouble Code Description for P0520 Isuzu

Engine Oil Pressure Sensor/Switch Circuit

What does this mean?

OBD2 Code P0520 Isuzu definition:
The PCM continuously monitors the engine oil pressure. The Oil Pressure Sensor/Switch sends a signal to the PCM when the engine is running.

Symptoms

Possible sumptoms of OBD code P0520 Isuzu
– Engine Light ON (or Service Engine Soon Warning Light) – Oil pressure warning light ON.

Causes

Possible causes of OBD code P0520 Isuzu
– Low oil level or motor mechanical fault – Open or short oil level sensor circuit condition – Poor oil level sensor electrical connection – Faulty oil pressure sensor The Error code is generally activated on detection of the following conditions: The P0520 Isuzu is detected when the circuit from oil pressure sensor to PCM is malfunction

Possible Solutions

The most likely cause is a faulty oil pressure sensor/switch


The OBD2 Code Information Be Applicable For Isuzu:

2011 Isuzu Rodeo 3.0 Denver,2008 Isuzu Pickup,2007 Isuzu Ascender,2002 Isuzu Axiom XST Concept,2002 Isuzu Axiom XSR Concept,2001 Isuzu Zen Concept,2001 Isuzu GBX Concept,2001 Isuzu Axiom XSF Concept

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Isuzu makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.