Description
OBD-II Trouble Code Description for P0610 Isuzu
Control Module Vehicle Options Error
What does this mean?
OBD2 Code P0610 Isuzu definition:
The ECM continuously monitors its internal memory status, internal circuits, and output signals to the throttle actuator. This self?check insures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the code and illuminate the engine light.
Symptoms
Possible sumptoms of OBD code P0610 Isuzu
– Engine Light ON (or Service Engine Soon Warning Light) – Engine may not start
Causes
Possible causes of OBD code P0610 Isuzu
– ECM Harness power supply circuit is open or shorted – ECM Programing – Faulty ECM The Error code is generally activated on detection of the following conditions: The ECM is programmed for an automatic/manual transmission but is detecting the opposite
Possible Solutions
– Resecure ECM connectors – Reprogram ECM – Replaced ECM
The OBD2 Code Information Be Applicable For Isuzu:
2011 Isuzu Rodeo 3.0 Denver,2008 Isuzu Pickup,2007 Isuzu Ascender,2002 Isuzu Axiom XST Concept,2002 Isuzu Axiom XSR Concept,2001 Isuzu Zen Concept,2001 Isuzu GBX Concept,2001 Isuzu Axiom XSF Concept
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Isuzu makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.