Isuzu P1324 Alignment Between Camshaft and Crankshaft Signal

Description

Ferrari OBD-II Trouble Code Description for P1324 Isuzu

Alignment Between Camshaft and Crankshaft Signal

Possible Solutions

Mech. Adjusted (min/max) 1 Check the wiring, PG3 sensor 2 Check crankshaft signal and Camshaft signal with oscilloscope ————– ————- FG3 – – – – – – – DG Number of teeth has to be 60-2 2 Check crankshaft signal and Camshaft signal with oscltlotcope when variable camshaft is active

OBD-II Trouble Code Description for P1324 Isuzu

Crank RPM Too Low

OBD-II Trouble Code Description for P1324 Isuzu

Glow Relay – Malfunction

VAG OBD-II Trouble Code Description for P1324 Isuzu

Knock Sensor 4 Circ. High Input

The OBD2 Code Information Be Applicable For Isuzu:

2011 Isuzu Rodeo 3.0 Denver,2008 Isuzu Pickup,2007 Isuzu Ascender,2002 Isuzu Axiom XST Concept,2002 Isuzu Axiom XSR Concept,2001 Isuzu Zen Concept,2001 Isuzu GBX Concept,2001 Isuzu Axiom XSF Concept

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Isuzu makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.