Land Rover P0717 Input Shaft Speed Sensor Circuit No Signal

Description

OBD-II Trouble Code Description for P0717 Land Rover

Input/Turbine Speed Sensor “A” Circuit No Signal

What does this mean?

OBD2 Code P0717 Land Rover definition:
The input speed sensor detects the primary pulley revolution speed and sends a signal to the Transmission Control Module (TCM) and Engine Control Module (ECM).

Symptoms

Possible sumptoms of OBD code P0717 Land Rover
– Engine Light ON (or Service Engine Soon Warning Light) – Possible shifting problems

Causes

Possible causes of OBD code P0717 Land Rover
– Transmission speed sensor circuit is open or shorted. – Poor transmission speed sensor circuit connection – Faulty transmission speed sensor The Error code is generally activated on detection of the following conditions: Diagnostic Trouble Code (DTC) P0717 Land Rover is detected when TCM or ECM receives no signal from the sensor.

Possible Solutions


The OBD2 Code Information Be Applicable For Land Rover:

2013 Land Rover,2012 Land Rover,2011 Land Rover,2010 Land Rover,2009 Land Rover ,2008 Land Rover,2007 Land Rover,2006 Land Rover,2005 Land Rover,2004 Land Rover,2003 Land Rover,2002 Land Rover

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Land Rover makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.