Description
OBD-II Trouble Code Description for P0298 Opel
Engine Oil Over Temperature
What does this mean?
OBD2 Code P0298 Opel definition:
Indicates the Engine Oil Temperature Protection (EOT) strategy in the Power Train Control Module (PCM) has been activated. This temporarily prohibits high engine speed operation by disabling injectors, reducing the risk of engine damage from high engine oil temperature. Note: On engines which are equipped with an oil temperature sensor, the PCM reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the PCM uses an oil algorithm to infer actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.
Symptoms
Possible sumptoms of OBD code P0298 Opel
– Engine Light ON (or Service Engine Soon Warning Light) – Lack/Loss of Power – Engine Surge
Causes
Possible causes of OBD code P0298 Opel
– Very high engine RPM for an extended period of time. – Overheating condition. – Malfunction EOT sensor or circuit (vehicles w/EOT sensor). The Error code is generally activated on detection of the following conditions: P0298 Opel is set when the vehicle has been running below 1,000 rpm and less than 20 mg/stroke MFDES with EOT sensor signal reading above 110?C (230?F). The time to set the fault is dependent on EOT and Intake Air Temperature (IAT) temperatures, and can vary between approx. 15 to 45 minutes
Possible Solutions
1. Inspect EOT sensor circuitry at sensor and PCM. Inspect for damage, loose or pushed-out pins, loose or poorly crimped wires 2. If connectors are ok check cooling system, radiator, fan/clutch operation, thermostat 3. If cooling system is ok carry out KOEO On-Demand Self Test 4. If other fault codes are present after test repair them, if only P0298 Opel is present clear codes 5. Let vehicles sit for 8 hours and then KOEO 6. Monitor EOT in live data 7. If EOT sensor reading is above 110*C(230*F) replace sensor 8. IF EOT is below 110*C check continuous memory DTCs 9. If P0298 Opel is present replace PCM
The OBD2 Code Information Be Applicable For Opel:
2013 Opel Astra OPC,2013 Opel Adam,2012 Opel Zafira Tourer,2012 Opel Combo,2012 Opel Astra GTC,2012 Opel Ampera,2011 Opel Zafira,2011 Opel Meriva,2011 Opel Corsa,2011 Opel Astra,2011 Opel Antara,2010 Opel Insignia,2010 Opel Corsa,2010 Opel Astra,2008 Opel Corsa,2007 Opel GT,2007 Opel Corsa,2007 Opel Astra,2007 Opel Antara,2006 Opel Vectra,2006 Opel Meriva,2006 Opel Astra,2005 Opel Astra,2004 Opel Astra,2003 Opel Signum,2003 Opel Meriva
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Opel makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.