P0017 SAAB Crankshaft Position Camshaft Position Correlation Bank 1 Sensor B

Possible causes
– Dirty Oil
– Engine mechanical problems
– Faulty camshaft position sensor
– Faulty crankshaft position sensor
– Timing belt jumped
Tech description
There is a factory service bulletin for the following Saab models:

2004-2009 Saab 97x
2004-2009 Saab 97x Factory Service Bulletin OBDII Code P0017

Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P0017 SAAB OBD Code Description

The Camshaft Position (CMP) actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is operating. The CMP actuator solenoid signal from the ECM is pulse width modulated (PWM). The ECM control the CMP actuator solenoid duty cycle by controlling the amount of solenoid IN time. The CMP actuator solenoid controls the advance or retard of each camshaft. The CMP actuator solenoid control the oil flow that applies the pressure to advance or retard the camshafts.4

Ignition voltage is supplied directly to the CMP actuator solenoid. The ECM control the solenoid by grounding the control circuit with a solid state device called a driver. Th ECM compares the camshaft position or the camshaft angle, to the position of the crankshaft. If the ECM detects a deviation between the camshaft position target and the crankshaft position, the code will set.

SAAB Related P0017 code
2005 SAAB 9-7X Engine And Engine Cooling:engine
2005 SAAB 9-7X Engine And Engine Cooling:engine
2006 SAAB 9-7X Engine And Engine Cooling:engine
2006 SAAB 9-7X Engine And Engine Cooling:engine