P0123 JEEP Throttle Position Sensor/Accelerator Position Pedal Circuit High Input

Possible causes
– Faulty throttle position sensor
– Throttle position sensor harness is open or shorted
– Throttle position sensor circuit poor electrical connection
– Faulty Powertrain Control Module (PCM)
When is the obd code mean?
The P0123 code will set if the monitored TPS volts rise above 4.94 volts for the peroid of 0.48 seconds
Symptoms
– Engine Light ON (or Service Engine Soon Warning Light)
P0123 JEEP OBD Code Description

The Throttle Position Sensor (TPS) responds to the accelerator pedal movement. This sensor is a kind of potentiometer which transforms the throttle position into output voltage, and emits the voltage signal to the Powertrain Control Module (PCM). In addition, the sensor detects the opening and closing speed of the throttle valve and feeds the voltage signal to the PCM.

Idle position of the throttle valve is determined by the PCM receiving the signal from the throttle position sensor. This sensor controls engine operation such as fuel cut. On the other hand, the Wide open and closed throttle position switch, which is built into the throttle position sensor unit, is not used for engine control.

JEEP Related P0123 code
2007 JEEP LIBERTY Engine And Engine Cooling:engine
2008 JEEP LIBERTY Engine And Engine Cooling:engine
2009 JEEP LIBERTY Engine And Engine Cooling:engine
2007 JEEP CHEROKEE Engine And Engine Cooling:engine
2008 JEEP CHEROKEE Engine And Engine Cooling:engine
2009 JEEP CHEROKEE Engine And Engine Cooling:engine