P0440 INFINITI EVAP Control System Small Leak

Possible causes

– Missing or loose fuel cap
– Incorrect fuel filler cap used
– Fuel filler cap remains open or fails to close
– Foreign matter caught in fuel filler cap
– EVAP canister or fuel tank leaks
– EVAP system hose leaking
– Fuel tank leaking

Tech description

The P0440 code means that the control module has detected a leak in the Evaporative Emission (EVAP). Loose fuel tank filler cap is the most common cause that triggers the P0440 code.

There is an Infiniti Service Bulletin to help diagnose the P0440 code:
Infiniti OBDII Code P0440

When is the obd code mean?

Malfunction is detected when EVAP control system has a leak, EVAP control system does not operate properly.

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)
– Possible a noticeable fuel odor caused by the release of fuel vapors

P0440 INFINITI OBD Code Description

The Engine Control Module (ECM) tests the Evaporative Emission (EVAP) system for the following conditions:

– Large and small leaks

– Excess vacuum

– Purge flow during non-commanded conditions

– Fuel Level and Fuel Pressure sensor faults

– EVAP Purge and Vent Valve faults

The ECM monitors the Fuel Tank Pressure sensor in order to determine the level of vacuum/pressure in the EVAP system. The ECM commands both the EVAP Purge Solenoid and the EVAP Vent Valve ON when the conditions are met in order to apply an engine vacuum to the EVAP system. The ECM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP system. Failure to develop a vacuum may be caused by a large leak or a restriction.