P0441 DODGE EVAP Purge System Performance

Possible causes

– EVAP purge solenoid vacuum supply
– EVAP purge hose/tube obstruction
– EVAP purge solenoid vacuum supply-evap system leak
– Faulty Powertrain Control Module (PCM)

Tech description

The P0441 code means that the control module has detected a leak in the Evaporative Emission (EVAP). Loose fuel tank filler cap is the most common cause that triggers the P0441 code.

When is the obd code mean?

Pressure in charcoal canister and fuel tank does not drop during purge control (2 trip detection logic)

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)
– Possible a noticeable fuel odor caused by the release of fuel vapors

P0441 DODGE OBD Code Description

The Powertrain Control Module (PCM) tests the Evaporative Emission (EVAP) system for the following conditions:

– Large and small leaks

– Excess vacuum

– Purge flow during non-commanded conditions

– Fuel Level and Fuel Pressure sensor faults

– EVAP Purge and Vent Valve faults

The PCM monitors the Fuel Tank Pressure sensor in order to determine the level of vacuum/pressure in the EVAP system. The PCM commands both the EVAP Purge Solenoid and the EVAP Vent Valve ON when the conditions are met in order to apply an engine vacuum to the EVAP system. The PCM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP system. Failure to develop a vacuum may be caused by a large leak or a restriction.