P0732 DODGE Gear Ratio Error In Second Gear

Possible causes

– Low transmission fluid level
– Dirty transmission fluid
– Faulty Shift Solenoids
– Shift Solenoids harness is open or shorted
– Shift Solenoids circuit poot electrical connection
– Transmission mechanical problems
– Transmission hydraulic control circuit

Tech description

Start by inspecting the transmission fluid level and condition, and change fluid if necessary.

When is the obd code mean?

The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)
– Incorrect transmission shifting

P0732 DODGE OBD Code Description

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor

B: Engine speed signal from Engine Control Module (ECM)

C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (2nd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

DODGE Related P0732 code