P1320 NISSAN Ignition Signal

Possible causes

– Faulty power transistor unit built into ignition coil
– Ignition primary circuit is open or shorted (circuit to ignition coils)
– Ignition primary circuit poor electrical connection (circuit to ignition coils)
– Faulty ignition system condenser
– Crankshaft position sensor circuit

Tech description

The most common cause that will trigger the P1320 code is the ignition coils, one or more ignition coils may have failed. Even tough the coils may be working OK, the resistance for one or more of the coils is greater or smaller that what the Engine Control Module (ECM) is expecting. Measuring the resistance with the coil out of the vehicle may not show any failures, usually the coil fails under heavy conditions (hard acceleration) or certain temperatures.

The P1320 code means that there is problem with the “Ignition Coil” or the wire to the ignition coil. For some models without individual ignition coils the Ignition Coil is inside the distributor and the distributor need to be replaced to fix the problem.

When is the obd code mean?

When the ignition signal in the primary circuit is not sent to Engine Control Module (ECM) during engine cranking or running.

Symptoms

– Engine Light ON (or Service Engine Soon Warning Light)

P1320 NISSAN OBD Code Description

The ignition signal from the Engine Control Module (ECM) is sent to and amplified by the power transistor. The power transistor turns on and off the ignition coil primary circuit. This on-off operation induces the proper high voltage in the coil secondary circuit.

NISSAN Related P1320 code