Renault P1000 OBD system readiness test not complete

Description

OBD-II Trouble Code Description for P1000 Renault

OBD-II Monitor Testing Incomplete

OBD-II Trouble Code Description for P1000 Renault

OBD system readiness test not complete

What does this mean?

OBD2 Code P1000 Renault definition:
The OBD monitors are performed during the OBD Drive Mode. The P1000 Renault will be stored in continuous memory if any of the OBD monitors do not complete their full diagnostic check.

Causes

Possible causes of OBD code P1000 Renault
? Vehicle is new from the factory ? Battery or PCM had recently been disconnected ? An OBD monitor failure had occurred before completion of an OBD drive mode ? The PCM DTCs have recently been cleared with a M-MDS ? The PCM has been flashed and the vehicle has not yet completed an OBD drive mode.

Possible Solutions

Diagnostic procedure

STEP

INSPECTI RenaultON

ACTION Renault

1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDE RenaultD
???Has the FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY REPAIR INFORMATION AVAILABILIT RenaultY
???Verify related service repair information availability.
???Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
CHECK Renault FOR ANY OTHER DTCS
???Where any other DTCs received with the P1000 Renault?
Yes
Go to the applicable DTC inspection.
No
Go to the next step.
4
REQUEST TO CLEAR Renault DTC P1000 Renault
Note
???A complete OBD drive mode has not yet been performed to clear the DTC P1000 Renault from the PCM.

???Has the customer requested the DTC P1000 Renault be cleared?
Yes
Complete an OBD drive mode, then go to the next step.
No
Inform the customer that if the law in your area required additional driving in order to clear the DTC P1000 Renault from the PCM memory, it must be complete before an inspection/maintenance test.
5
VERIFY THAT DTC P1000 Renault TROUBLES RenaultHOOTING IS COMPL RenaultETED
???Make sure to reconnect all disconnected connectors.
???Clear the DTC from the PCM memory using the M-MDS.
???Start the engine and warm-up to normal operating temperature.
???Run the vehicle under the FREEZE FRAME DATA stored condition.
???Retrieve the DTC using the M-MDS.
???Is the PENDI RenaultNG CODE same DTC present?
Yes
Replace PCM, then go to the next step.
No
Go to the next step.
6
VERIFY AFTER REPAIR PROCE RenaultDURE
???Perform “After Repair Procedure”.
???Is there any DTC present?
Yes
Go to the applicable DTC inspection.
No
Troubleshooting completed.

Mercedes OBD-II Trouble Code Description for P1000 Renault

Electronic Gear Selector Module: Defective N15/5


The OBD2 Code Information Be Applicable For Renault:

2013 Renault ZOE,2013 Renault Twin-Z Concept,2013 Renault Twin-Run Concept,2013 Renault Talisman,2013 Renault Symbol,2013 Renault Scenic XMOD,2013 Renault Fluence,2013 Renault Espace,2013 Renault Clio,2012 Renault Twingo,2011 Renault Megane,2011 Renault Latitude,2011 Renault Laguna Estate,2011 Renault Laguna,2011 Renault Frendzy Concept,2011 Renault Captur Concept,2010 Renault Scenic,2010 Renault Megane RS,2010 Renault Megane Estate,2010 Renault Grand Scenic,2010 Renault Fluence,2010 Renault DeZir Concept,2010 Renault Clio RS,2009 Renault Twingo RS,2009 Renault Symbol,2009 Renault Scenic,2009 Renault Safrane,2009 Renault Megane,2009 Renault Laguna GT,2009 Renault Laguna Coupe,2009 Renault Koleos,2009 Renault Kangoo,2009 Renault Clio Campus,2009 Renault Clio,2008 Renault ZE Concept,2008 Renault Twingo,2008 Renault Sandero,2008 Renault Laguna Estate,2008 Renault Laguna,2008 Renault Kangoo,2007 Renault Megane,2006 Renault Twingo,2006 Renault Thalia,2006 Renault Nepta Concept,2006 Renault Kangoo,2006 Renault Espace,2006 Renault Clio Sport,2006 Renault Clio RS Concept,2006 Renault Altica Concept,2005 Renault Z17 Concept,2005 Renault Vel Satis,2005 Renault Modus Initiale,2005 Renault Laguna,2005 Renault Clio III,2004 Renault Modus,2004 Renault Megane,2004 Renault Clio,2003 Renault Scenic II,2003 Renault Be Bop

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Renault makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.