Skoda P0736 Gear Ratio Error In Reverse Gear

Description

OBD-II Trouble Code Description for P0736 Skoda

Reverse Incorrect Ratio

What does this mean?

OBD2 Code P0736 Skoda definition:
This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows: Torque converter slip ratio = A x C/B A: Output shaft revolution signal from revolution sensor B: Engine speed signal from Engine Control Module (ECM) C: Gear ratio determined as gear position which TCM supposes

Symptoms

Possible sumptoms of OBD code P0736 Skoda
– Engine Light ON (or Service Engine Soon Warning Light) – Incorrect transmission shifting

Causes

Possible causes of OBD code P0736 Skoda
– Low transmission fluid level – Dirty transmission fluid – Shift solenoids – Transmission mechanical problems – Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: The ECM has detected that the transmission input RPM does not match the transmission output RPM under known conditions

Possible Solutions


The OBD2 Code Information Be Applicable For Skoda:

2013 Skoda Rapid,2013 Skoda Octavia,2013 Skoda Citigo,2011 Skoda Roomster,2011 Skoda Fabia,2010 Skoda Superb,2009 Skoda Superb,2009 Skoda Octavia,2008 Skoda Fabia,2007 Skoda Fabia,2006 Skoda Roomster,2006 Skoda Octavia,2005 Skoda Octavia,2005 Skoda Fabia,2003 Skoda Superb,2003 Skoda Octavia,2003 Skoda Fabia

 

Note:

1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Skoda makes.

2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.

3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.

4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.

5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.