Description
OBD-II Trouble Code Description for P1000 Skoda
OBD-II Monitor Testing Incomplete
Car obd codes, car OBD-ii codes, car Fault codes , Car Trouble codes, Car Error codes, diagnostic codes
OBD2 Code P1000 Skoda definition:
The OBD monitors are performed during the OBD Drive Mode. The P1000 Skoda will be stored in continuous memory if any of the OBD monitors do not complete their full diagnostic check.
Possible causes of OBD code P1000 Skoda
? Vehicle is new from the factory ? Battery or PCM had recently been disconnected ? An OBD monitor failure had occurred before completion of an OBD drive mode ? The PCM DTCs have recently been cleared with a M-MDS ? The PCM has been flashed and the vehicle has not yet completed an OBD drive mode.
Diagnostic procedure
STEP |
INSPECTI SkodaON |
ACTION Skoda |
|
---|---|---|---|
1
|
VERIFY FREEZE FRAME DATA HAS BEEN RECORDE SkodaD
???Has the FREEZE FRAME DATA been recorded?
|
Yes
|
Go to the next step.
|
No
|
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
|
||
2
|
VERIFY REPAIR INFORMATION AVAILABILIT SkodaY
???Verify related service repair information availability.
???Is any related repair information available?
|
Yes
|
Perform repair or diagnosis according to the available repair information.
If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
CHECK Skoda FOR ANY OTHER DTCS
???Where any other DTCs received with the P1000 Skoda?
|
Yes
|
Go to the applicable DTC inspection.
|
No
|
Go to the next step.
|
||
4
|
REQUEST TO CLEAR Skoda DTC P1000 Skoda
???Has the customer requested the DTC P1000 Skoda be cleared?
|
Yes
|
Complete an OBD drive mode, then go to the next step.
|
No
|
Inform the customer that if the law in your area required additional driving in order to clear the DTC P1000 Skoda from the PCM memory, it must be complete before an inspection/maintenance test.
|
||
5
|
VERIFY THAT DTC P1000 Skoda TROUBLES SkodaHOOTING IS COMPL SkodaETED
???Make sure to reconnect all disconnected connectors.
???Clear the DTC from the PCM memory using the M-MDS.
???Start the engine and warm-up to normal operating temperature.
???Run the vehicle under the FREEZE FRAME DATA stored condition.
???Retrieve the DTC using the M-MDS.
???Is the PENDI SkodaNG CODE same DTC present?
|
Yes
|
Replace PCM, then go to the next step.
|
No
|
Go to the next step.
|
||
6
|
VERIFY AFTER REPAIR PROCE SkodaDURE
???Perform “After Repair Procedure”.
???Is there any DTC present?
|
Yes
|
Go to the applicable DTC inspection.
|
No
|
Troubleshooting completed.
|
2013 Skoda Rapid,2013 Skoda Octavia,2013 Skoda Citigo,2011 Skoda Roomster,2011 Skoda Fabia,2010 Skoda Superb,2009 Skoda Superb,2009 Skoda Octavia,2008 Skoda Fabia,2007 Skoda Fabia,2006 Skoda Roomster,2006 Skoda Octavia,2005 Skoda Octavia,2005 Skoda Fabia,2003 Skoda Superb,2003 Skoda Octavia,2003 Skoda Fabia
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Skoda makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.