Description
OBD-II Trouble Code Description for P0341 Toyota
Camshaft Position Sensor “A” Circuit Range/Performance
What does this mean?
OBD2 Code P0341 Toyota definition:
This P0341 Toyota code basically means that the powertrain control module (PCM) detected a problem with the camshaft signal. The camshaft position sensor (CPS) sends a specific signal to the PCM for Top Dead Center on the compression stroke as well as signals indicating the position of the cam sensor. This is accomplished through a reluctor wheel attached to the camshaft that passes by the cam sensor. Any time that the signal to the PCM is inconsistent with what the signal should be, this code is set. NOTE: this code can also be set by extended cranking periods.
Symptoms
Possible sumptoms of OBD code P0341 Toyota
The car will likely run with this code set, as it is often intermittent and also because the PCM can often operate the vehicle in “limp-in/limp-home” mode even with a cam sensor signal problem. There may be no noticeable symptoms other than: Poor fuel economy (if engine runs) Possible no start condition
Causes
Possible causes of OBD code P0341 Toyota
A code P0341 Toyota may mean that one or more of the following has happened: Cam sensor wiring routed too close to spark plug wiring (causing interference) Poor wiring connection at cam sensor Poor wiring connection at PCM Bad cam sensor Damaged reluctor wheel
Possible Solutions
Often relacing the sensor fixes this code, but not necessarily. Therefore it’s important to check the following: Check that the wiring isn’t routed too close to any secondary ignition components (coil, spark plug wires, etc.) Visually inspect the wiring at the sensor for any burn marks, discoloration indicative of melting or chafing Visually inspect the cam sensor for damage Visually inspect the reluctor wheel through the cam sensor port (if possible) for any missing teeth or any damage If reluctor isn’t visible from outside the engine, visual test can only be done by removing cam shaft or intake manifold (depending on engine design) If all checks out okay, then replace the sensor. Related Camshaft Trouble Codes: P0340 Toyota
The OBD2 Code Information Be Applicable For Toyota:
2013 Toyota Auris,2012 Toyota Yaris,2012 Toyota Verso-S,2012 Toyota Tacoma,2012 Toyota Prius V,2012 Toyota Prius C,2012 Toyota Prius,2012 Toyota Hilux,2012 Toyota Camry,2012 Toyota Avensis,2012 Toyota Aurion,2012 Toyota 86 GTS,2011 Toyota Tacoma,2011 Toyota Sienna,2011 Toyota Sequoia,2011 Toyota RAV4,2011 Toyota Matrix,2011 Toyota Highlander,2011 Toyota Corolla,2011 Toyota Avalon,2011 Toyota Auris HSD,2010 Toyota iQ3,2010 Toyota Yaris,2010 Toyota Verso,2010 Toyota Tundra,2010 Toyota Prius,2010 Toyota Land Cruiser,2010 Toyota Corolla,2010 Toyota Camry,2010 Toyota Auris,2010 Toyota 4Runner,2009 Toyota iQ,2009 Toyota Yaris,2009 Toyota Venza,2009 Toyota RAV4,2009 Toyota Matrix,2009 Toyota Hilux,2009 Toyota Aygo,2009 Toyota Avensis,2009 Toyota Aurion,2009 Toyota 4Runner,2008 Toyota Sequoia,2007 Toyota Tundra,2007 Toyota Avensis,2006 Toyota RAV4,2006 Toyota Aurion,2005 Toyota Corolla Sedan,2004 Toyota Prius,2004 Toyota Corolla,2003 Toyota RAV4,2003 Toyota Land Cruiser,2003 Toyota Celica
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Toyota makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.