Description
OBD-II Trouble Code Description for P0208 Volkswagen
Injector Circuit/Open – Cylinder 8
What does this mean?
OBD2 Code P0208 Volkswagen definition:
P0207 Volkswagen means that the PCM detected a fault in the injector or the wiring to the injector. It monitors the injector and when the injector is activated, the PCM expects to see the voltage pulled “low” or close to zero. When the injector is switched off, the PCM expects to see a voltage that is close to battery voltage or “high”. If it doesn’t see the expected voltage the PCM will set this code. The PCM also monitors resitance in the circuit. If the resistance is excessively low or high it will set this code.
Symptoms
Possible sumptoms of OBD code P0208 Volkswagen
The symptoms for this code will likely be a misfire and a rough running engine. Poor acceleration. The MIL will also be illuminated.
Causes
Possible causes of OBD code P0208 Volkswagen
The causes of a P0207 Volkswagen engine light code could be any of the following: Bad injector. This is usually the cause of this code but doesn’t rule out the possibility of one of the other causes Open in the wiring to the injector Short in the wiring to the injector Bad PCM
Possible Solutions
First, using a DVOM check the resistance of the injector. If it isn’t within specs, then replace the injector. Check for voltage at the fuel injector connector. It should have 10 volts or more. Visually check the connector for damage or broken wires. Visually check the injector for damage. If you have access to an injector tester, activate the injector and see if it operates. If the injector operates, then you likely have either an open in the wiring, or a blocked injector. If you do not have access to a tester, swap the injector with another one and see if the code changes. If the code changes, then change the injector. At the PCM, remove the driver wire from the PCM connector and Ground the wire. (Make sure you have the correct wire. If you’re not sure, do not attempt) The injector should activate Replace the injector First, using a DVOM check the resistance of the injector. If it isn’t within specs, then replace the injector. Check for voltage at the fuel injector connector. It should have 10 volts or more. Visually check the connector for damage or broken wires. Visually check the injector for damage. If you have access to an injector tester, activate the injector and see if it operates. If the injector operates, then you likely have either an open in the wiring, or a blocked injector. If you do not have access to a tester, swap the injector with another one and see if the code changes. If the code changes, then change the injector. At the PCM, remove the driver wire from the PCM connector and Ground the wire. (Make sure you have the correct wire. If you’re not sure, do not attempt) The injector should activate Replace the injector
The OBD2 Code Information Be Applicable For Volkswagen:
2013 Volkswagen e-Co-Motion Concept,2013 Volkswagen Up 4-door,2013 Volkswagen Up,2013 Volkswagen Touareg Edition X,2013 Volkswagen Scirocco GTS,2013 Volkswagen Santana,2013 Volkswagen Polo R WRC,2013 Volkswagen Polo BlueGT,2013 Volkswagen Passat Alltrack,2013 Volkswagen Lavida,2013 Volkswagen Kombi Last Edition,2013 Volkswagen Jetta Hybrid,2013 Volkswagen Golf Sportsvan Concept,2013 Volkswagen Golf Plus Life,2013 Volkswagen Golf Mk VII UK-Version,2013 Volkswagen Golf GTI Cabriolet,2013 Volkswagen Golf,2013 Volkswagen Gol 2-door,2013 Volkswagen Eco Up,2013 Volkswagen Caddy Cross,2012 Volkswagen Tiguan,2012 Volkswagen Jetta GLI,2012 Volkswagen Beetle,2011 Volkswagen eT Concept,2011 Volkswagen e-Up Concept,2011 Volkswagen XL1 Concept,2011 Volkswagen Touran,2011 Volkswagen Touareg,2011 Volkswagen Sharan,2011 Volkswagen Polo GTI,2011 Volkswagen Phaeton,2011 Volkswagen Jetta,2011 Volkswagen Eos,2011 Volkswagen CrossTouran,2011 Volkswagen CrossPolo,2011 Volkswagen CrossGolf,2011 Volkswagen Amarok,2010 Volkswagen Polo,2010 Volkswagen Golf,2009 Volkswagen Phaeton,2009 Volkswagen Golf,2009 Volkswagen Gol,2008 Volkswagen Phaeton,2008 Volkswagen Golf Variant,2008 Volkswagen Golf GTI Concept,2008 Volkswagen Golf BlueMotion,2007 Volkswagen Up Concept,2007 Volkswagen Touran,2007 Volkswagen Touareg,2007 Volkswagen Eos,2006 Volkswagen Rabbit,2006 Volkswagen Passat,2006 Volkswagen Jetta,2006 Volkswagen Eos,2006 Volkswagen CrossPolo,2005 Volkswagen Touareg,2005 Volkswagen Golf,2005 Volkswagen Fox,2004 Volkswagen RaceTouareg,2004 Volkswagen Golf,2004 Volkswagen Concept T,2004 Volkswagen Concept C,2003 Volkswagen Touran,2003 Volkswagen Passat
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Volkswagen makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.