Description:
OBD-II Trouble Code Description for P0298 Volvo
Engine Oil Over Temperature
What does this mean?
OBD2 Code P0298 Volvo definition:
Indicates the Engine Oil Temperature Protection (EOT) strategy in the Power Train Control Module (PCM) has been activated. This temporarily prohibits high engine speed operation by disabling injectors, reducing the risk of engine damage from high engine oil temperature. Note: On engines which are equipped with an oil temperature sensor, the PCM reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the PCM uses an oil algorithm to infer actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.
Symptoms
Possible sumptoms of OBD code P0298 Volvo
– Engine Light ON (or Service Engine Soon Warning Light) – Lack/Loss of Power – Engine Surge
Causes
Possible causes of OBD code P0298 Volvo
– Very high engine RPM for an extended period of time. – Overheating condition. – Malfunction EOT sensor or circuit (vehicles w/EOT sensor). The Error code is generally activated on detection of the following conditions: P0298 Volvo is set when the vehicle has been running below 1,000 rpm and less than 20 mg/stroke MFDES with EOT sensor signal reading above 110?C (230?F). The time to set the fault is dependent on EOT and Intake Air Temperature (IAT) temperatures, and can vary between approx. 15 to 45 minutes
Possible Solutions
1. Inspect EOT sensor circuitry at sensor and PCM. Inspect for damage, loose or pushed-out pins, loose or poorly crimped wires 2. If connectors are ok check cooling system, radiator, fan/clutch operation, thermostat 3. If cooling system is ok carry out KOEO On-Demand Self Test 4. If other fault codes are present after test repair them, if only P0298 Volvo is present clear codes 5. Let vehicles sit for 8 hours and then KOEO 6. Monitor EOT in live data 7. If EOT sensor reading is above 110*C(230*F) replace sensor 8. IF EOT is below 110*C check continuous memory DTCs 9. If P0298 Volvo is present replace PCM
The OBD2 Code Information Be Applicable For Volvo:
2013 Volvo V40,2012 Volvo XC60,2011 Volvo XC90,2011 Volvo V60,2011 Volvo S60,2011 Volvo C30,2010 Volvo S80L,2010 Volvo S80,2010 Volvo C70,2010 Volvo C30,2009 Volvo XC60,2009 Volvo V50,2009 Volvo S60,2009 Volvo S40,2009 Volvo C30,2008 Volvo XC70,2008 Volvo V70,2008 Volvo V50,2008 Volvo S40,2007 Volvo V70,2007 Volvo S80,2007 Volvo S60,2007 Volvo C70,2007 Volvo C30,2006 Volvo XC90,2006 Volvo S80,2006 Volvo C70,2005 Volvo V50,2005 Volvo S60,2004 Volvo XC90,2004 Volvo V70,2004 Volvo V50,2004 Volvo V40,2004 Volvo S40,2003 Volvo V70 R,2003 Volvo S80,2003 Volvo S60 R
Note:
1. The list of automotive Makes at the right edge of the screen. The currently selected ODB-ii codes is for the Volvo makes.
2. Look up the other OBD II Trouble Codes, please use the search box. Enter the 5 character trouble codes in the search box and submit the search.
3. Don’t assume a particular OBD-II code means the same for other auto manufacturers as there are many makes specific codes in use.
4. If your OBD-II trouble codes are for a different car, select that vehicle series before searching for the diagnostic codes because not all OBD2 codes used by one manufacture are used by the other makes.
5. The information contained on this site is presented for informational purposes only. We are not responsible for any actions you take on your vehicle. If you have any doubt as to repairs on your vehicle, please contact your technician.